7.3 Installation of the KX-TDA30 Maintenance Console
Installation Manual 397
1. Connect the PC to the Hybrid IP-PBX with a
USB cable.
2. Start the KX-TDA30 Maintenance Console
from the start menu.
3. Type the Installer Level Programmer Code
(default: 1234), then click [OK].
The Programmer Code authorises different
programming levels, and the Quick Setup is
only available when you start the KX-TDA30
Maintenance Console with the Installer Level
Programmer Code.
Note
There are 2 other Programmer Codes
with limited authorisation: Administrator
Level (default: 1111), and User Level
(default: none).
4. Click "Connect" "USB" from the menu bar.
5. Type the system password for installer
(default: 1234), then click [OK] to log-in.
6. When country/area data do not match:
a. Click [OK] to replace the country/area
data of the Hybrid IP-PBX. Replacement
may take several minutes to complete.
b. Follow the procedure described in
"6.12.1 Starting the Hybrid IP-PBX" and
restart the Hybrid IP-PBX.
c. Repeat steps 2 to 4 to restart the KX-
TDA30 Maintenance Console.
To Next Page
Loading...
