466
16. Materials
Removing dirt on the image sensor
The image sensor is very precise and delicate, so be sure to observe the
following when you do have to clean it yourself.
• Blow dust off the surface of the image sensor using a commercially available
blower. Do not blow the dust off with excessive power.
• Do not put the blower brush further inside than the lens mount as the image sensor
may get scratched.
• Do not use any objects except a blower brush to clean the image sensor.
• If you cannot remove the dirt or dust with the blower, consult the dealer or
Panasonic.

Cleaning the Viewfinder
• As the eye cup cannot be removed, blow away the dust on the viewfinder surface
with a blower (commercially available), gently wipe it with a dry and soft cloth, and
be careful not to remove it.
• If you wipe the eye cup too hard and it is removed, consult the dealer or
Panasonic.

Monitor/Viewfinder
• Do not push hard on the monitor.
This may cause irregular coloration or malfunction.
• Extremely high precision technology is employed to produce the monitor/viewfinder
screen. However there may be some dark or bright spots, or spots that light
constantly (red, blue, or green) on the screen.
This is not a malfunction.
Though the monitor/viewfinder screen parts are produced with highly controlled
precision technology, some pixels may be inactive or always lit.
The spots will not be recorded on images on a card.
To Next Page
Loading...
Need help?
General
