124
Recording Modes
∫ Setting the light source
You can change the position and size of the light source.
1 Press [Fn2] to display the setting screen.
•
Setting screen can also be displayed by touching in order of [ ] then [ ].
2 Press 3
/
4
/
2
/
1 to move the centre position of the
light source
.
• The position of the light source can also be moved by
touching the screen.
• The centre of the light source can be moved to the edge of
the screen.
3 Adjust the size of the light source by rotating the rear
dial.
•
It can be changed to 4 different sizes.
• The display can also be enlarged/reduced by pinching out/
pinching in.
• Pressing [DISP.] or touching [Reset] returns the light
source setting to the default setting.
4 Press [MENU/SET] to set.
•
You can also set by touching [Set].
• Display of the recording screen will be delayed more than usual and the screen will look as if
frames are dropping.
Point for when placing the centre of the light source
A more natural appearance can be created by placing the centre of the light source
outside the image.
To Next Page
Loading...
