356
Others
• Is the subject focused?
> [Focus/Release Priority] is set to [FOCUS] at the time of purchase, and so you cannot take
pictures until the subject is in focus. If you want to be able to take a picture when you press
the shutter button fully even if the subject is not focused, set [Focus/Release Priority] in the
[Custom] menu to [RELEASE]. (P157)
• Picture might look whitish when lens or image sensor gets dirty with fingerprints or similar.
> If the lens is dirty turn the camera off and then gently wipe the lens surface with a soft, dry
cloth.
> Refer to P372 when the image sensor gets dirty.
> Check that the exposure is correctly compensated. (P166)
• Is the AE Lock (P164) applied incorrectly?
> Cancel the settings of White Balance Bracket (P138).
• Is the Burst (P179) or Auto Bracket (P183) set?
> Set the drive mode to Single. (P65)
• Is the self-timer (P186) set to [ ]?
• The subject is beyond the focus range of the camera. (P66)
• There is camera shake (jitter) or the subject is moving slightly. (P204)
• Is [Focus/Release Priority] in the [Custom] menu set to [RELEASE]? (P157)
In this case, focus may not be achieved even if the
focus mode lever is set to [AF].
• Is [Shutter AF] in the [Custom] menu set to [OFF]? (P156)
• Is the AF Lock (P164) applied incorrectly?
Taking pictures is not possible.
The shutter will not operate immediately when the shutter button is pressed.
The recorded picture is whitish.
The recorded picture is too bright or dark.
Multiple pictures are taken at one time.
The subject is not focused properly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
