358
Others
• When recording under fluorescent or LED lighting fixture, etc., increasing the shutter speed
may introduce slight changes to brightness and colour. These are a result of the characteristics
of the light source and do not indicate a malfunction.
• When recording subjects in extremely bright locations or recording under fluorescent lighting,
LED lighting fixture, mercury lamp, sodium lighting, etc., the colours and screen brightness may
change or horizontal striping may appear on the screen.
• There may be defective pixels in the image sensor. Perform [Pixel Refresh] (P60).
• Are you in Exposure Compensation operation?
> Press the rear dial to switch to Exposure Compensation operation. (P166)
• Set the AF area to the distinctive colour of the subject if there is a part that is different from the
surrounding colour. (P150)
• Is your finger covering up the speaker? (P13)
• If the camera is moved too slowly, the camera has assumed that camera motion was stopped
and will end the still picture recording.
• If there is a great deal of shaking towards the recording direction while moving the camera,
recording will end.
The brightness or the hue of the recorded picture is different from the actual
scene.
Bright spot not in subject is recorded.
You cannot compensate the exposure.
Subject cannot be locked.
(AF tracking not possible)
Operation sound is small.
Recording with [Panorama Shot] in Scene Guide Mode stops in the middle.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
