Parker Service Master CONNECT - Completing a Measurement

ENGLISH
6.6 Completing a Measurement
The description below explains how to complete a measurement ac-
cording to an example:
1 Switch the device on. Further information is available in Chapter
& "Switching the Device On and Off" on Page171.
2 Connect the sensors to the device according to your application.
Further information is available in Chapter & "Connecting the
Sensors" on Page172.
3 Setup the channels displayed according to your application. Fur-
ther information is available in Chapter & "Edit Channels" on
Page200.
4 Select a measuring method. Further information is available in
Chapter & "Measuring Methods" on Page204.
5 Tap on the Start/Stop button to start a measurement. Alterna-
tively, wait until the defined trigger is triggered.
Ä Recording of the measured data is started.
6 To stop the measurement, based on the measuring method se-
lected:
Tap on the Start/Stop button, wait for the defined storage time
to expire, wait for the defined trigger to trigger.
Ä Recording of the measured data is stopped.
After recording is stopped, the measured data is saved in the Ser-
vice Project Container (SPC) at the defined storage location. Further
information is available in Chapter & "Project Management" on
Page220.
You can access the measured data via the File Manager in order to
complete evaluations. Further information is available in Chapter
& "File Manager" on Page226.
219
The Parker Service Master CONNECT V1.0/04/20
Operation