Parker Service Master CONNECT - Fig. 49 PIN Assignment of Sensors Without Sensor Detection

ENGLISH
Sensors Without Sensor Detection
There are two methods with which to connect sensors without sensor
detection to the device.
Method 1: Direct connection to the analog IN4/5 connection on the
analog input module (SCMI-600-01) in accordance with the figure:
2 1
5
43
Fig.49 PIN assignment of sensors without sensor detection
PIN Designation
1 +Ub (+24VDC)
2 Measuring signal 1 (IN4)
3 GND
4 Measuring signal 2 (IN5)
5 GND
Method 2: Use of an adapter (current/voltage converter). The adapter is
connected between the sensors without sensor detection and the con-
nection for analog sensors with automatic sensor detection (IN1-IN3).
If a sensors without sensor detection is connected to the device using
this method, further configurations must be completed in the corre-
sponding menu.
INFORMATION
Further information on connecting sensors without sensor detection
via an adapter and the relevant parameters for configuration is avail-
able in the manual supplied with the respective sensor.
237
The Parker Service Master CONNECT V1.0/04/20
Operation