Call router configuration task list 499
SmartWare Software Configuration Guide 40 • Call router configuration
Invalid Message
(Cont.)
call-identity-in-use
Drop original call This cause indicates that the network has
received a call suspends request. The call
suspend request contained a call identity
which is already in use for a suspended
call within the domain of interfaces over
which the call might be resumed.
no-call-suspended
Drop original call The network receives a call resume request
when there is not a suspended call pend-
ing. This can be a transient error that will
be resolved by successive call retries.
call-has-been-cleared
Drop original call The network receives a call resume
request. This call resume request contains
a call identity that once indicated a sus-
pended call. However, the suspended call
was cleared either by time-out or by the
remote user.
incompatible-destination
Drop original call Indicates that an attempt is made to con-
nect incompatible equipment.
invalid-transit-network
Drop original call This cause indicates that a transit network
identification of an incorrect format was
received.
invalid-message
Drop original call Received an invalid message with no stan-
dard cause.
Protocol Error
mandatory-ie-missing Drop original call The receiving equipment receives a
message that does not include one of the
mandatory information elements. This
cause indicates that the equipment
sending this cause has received a
message that is missing a call property
that must be present in the message before
that message can be processed.
message-type-not-imple-
mented
Drop original call The receiving equipment receives an
unrecognized message, because the mes-
sage type is invalid or the message type is
valid but not supported.
message-type-not-state-
compatible
Drop original call The remote equipment receives an invalid
message with no standard cause. This
cause indicates that the equipment send-
ing this cause has received a message
such that the procedures do not indicate
that this is a permissible message to
receive while in the current call state.
Table 21. Hunt group drop causes (Continued)
Class Cause
Default Behavior
of the Hunt
Group Service
Description
To Next Page
Loading...