pellenc 200 - Page 73

73
"- LEVEL EXPERT- PELLENC POWER TOOL BATTERY" Workshop document
Issue 11/2016 ref. : DOCUMENT ATELIER_BATTERIE_EXP_OUTILS_PELLENC_V2_2016_ENG
BATTERY CYCLE
3/ Connecting the battery to the charger
•Checking the charge level of a battery.
PREREQUISITES:
1.To check the charge level of a battery the customer must charge his battery up to 99% steady.
2.Make sure that the battery has not been stored for more than 4 days.
3.Make sure that during the operating cycle, the tool is used until the battery stops with one beep every second and that the
display goes off.
4.With the diagnostics software, there must be a value in mVolts in the start of charge box.
or
If these conditions are not met, the battery charge level cannot be checked.
•Battery download
Listing check
Check full charging and
discharging after use in mVolts
LEVEL 3 - PELLENC AUTHORISED REPAIRER
Ź6WDUWDEDWWHU\FKDUJHHYHQLILWLVLQFRPSOHWHLWPXVWEHDERYHLQRUGHUWRLQFUHDVHDYDO
XHLQWKHRUYROWDJHRIWKH
lowest cell when the charger is connected at the next cycle" box
% or voltage of the lowest cell
when the charger is connected
at the next cycle
Check power consumption.