pellenc 200 - Page 89

89
"- LEVEL EXPERT- PELLENC POWER TOOL BATTERY" Workshop document
Issue 11/2016 ref. : DOCUMENT ATELIER_BATTERIE_EXP_OUTILS_PELLENC_V2_2016_ENG
4. Replacing a battery board
Pre-requisites:
• the battery test (Section 1.3) must be satisfactory
• the tool must be operational.
• the charger must be operational
1. Tool is inoperable and the battery test can be performed and is satisfactory
ĺ5HSODFHWKHEDWWHU\ERDUG
ĺ3HUIRUPEDWWHU\WHVW
2. Tool is inoperable and the battery test cannot be performed
ĺ5HSODFHWKHEDWWHU\ERDUG
ĺ3HUIRUPEDWWHU\WHVW
ĺ !,IEDWWHU\LVIDXOW\UHFRYHUWKHERDUGQHZDQGUHSODFHEDWWHU\DVVHPEO\
3. Charging is not possible
ĺ5HSODFHWKHEDWWHU\ERDUG
ĺ&KDUJHWKHEDWWHU\
ĺ3HUIRUPEDWWHU\WHVW
4. Tool works but the display does not work
ĺ5HSODFHWKHEDWWHU\ERDUG
ĺ3HUIRUPEDWWHU\WHVW
In all cases, the following is mandatory after repairing a battery:
ĺ7HVWLWZLWKDFKDUJHUWRVHHLIFKDUJLQJIXQFWLRQZRUNV
ĺ7HVWLWZLWKDWRROWRVHHLIWRRORXWSXWLVZRUNLQJFRUUHFWO\
DIAGNOSTICS FOR BATTERY COMPONENTS
LEVEL 3 - PELLENC AUTHORISED REPAIRER