Pentair AK110 - Page 120

120
AK110 Communications Screen for Cellular Modems (2 of 3)
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes >Check IP Signal Loop Restart EmailData# 1 @ hour # 8 cc Email# 3 Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, Check IP Address
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop Restart EmailData# 1 @ hour # 8 cc Email# 3 >Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, Data Interval Advanced Setup, Data Interval
Enter
Press the [Enter] key to set the time interval after which data packets will be to the Acu-Manage web site. The interval can be set from 0 minutes (no data ) to 240 minutes.
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop Restart EmailData# 1 @ hour # 8 cc Email# 3 >Data Interval: 15 Packet # 5 Send Data Packet
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop Restart EmailData# 1 @ hour # 8 cc Email# 3 Data Interval: 0 Packet # 5 >Send Data Packet
Advanced Setup, Send Data Packet
Press the [Enter] key to prompt the modem to immediately send a data packet to the Acu-Manage II web site.
Enter
Enter
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop Restart EmailData# 1 > @ hour # 8 cc Email# 3 Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, E-mail at Hour:
Enter new value Current: 8 8 v-Cancel ^
Send E-mail at Hour Screen
Enter
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop Restart EmailData# 1 @ hour # 8 > cc Email# 3 Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, Copy E-mail Address:
Enter new value Current: 3 3 v-Cancel ^
Copy E-mail Address Screen Use the keypad to enter the number of the e-mail address to which the last twelve recorded data sets are to be copied. For instance, the number "3" represents the third entry in the e-mail address book. Press the [Enter] key to confirm or the down arrow key to cancel. Use the keypad to enter the hour (on a 24-hour clock) at which the data is to be sent. For instance, the number "8" represents 8:00 am. Press the [Enter] key to confirm or the down arrow key to cancel.
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP >
Signal Loop
Restart EmailData# 1 @ hour # 8 cc Email# 3 Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, Signal Loop
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop >
Restart
EmailData# 1 @ hour # 8 cc Email# 3 Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, Restart Modem
Enter
IP=166.213.212.193 M#= ATT - 87dBm GOOD Signal CurrBytes987 HourBytes 456 Clear All Bytes Check IP Signal Loop Restart >
EmailData# 1
@ hour # 8 cc Email# 3 Data Interval: 0 Packet # 5 Send Data Packet
Advanced Setup, Send E-mail to:
Enter new value Current: 1 1 v-Cancel ^
Use the keypad to enter the number of the e-mail address to which the last twelve recorded data sets are to be sent. For instance, the number "1" represents the first entry in the e-mail address book. Press the [Enter] key to confirm or the down arrow key to cancel. Send E-mail to Address Screen
Enter
Press the [Enter] key to refresh the cellular modem IP address and display it on-screen.
Enter
Press the [Enter] key to continually search for a cellular signal until one is found. This provides the user with an opportunity to reposition the antenna for optimum signal reception.
Enter
Press the [Enter] key to restart the modem. The modem will disconnect from the network, reboot, search for a signal, and then reconnect to the cellular network.
From Commmunications Screen
for Cellular Modems (1 of 3)
www
Acu-
Manage
II
AK110 Communications Screen for Cellular Modems, Rev 3 21 Aug 2008