B3 Formwork utilisation
Utilisation of adjusting unit 44
Formwork alignment 45
Inclination adjustment 46
Horizontal movement – VARIO 46
B4 Moving the units
Preparation 47
Moving procedure 48
Securing the unit 49
C1 Planning and work preparation
Static system 50
Platform dimensioning 51
Anchoring verification 51
Platform decking 54
Handrails and guardrails 55
Connecting VARIO GT 24 formwork 56
Connecting TRIO formwork 58
Moving the units 60
Ladder access 61
Drawings and plans 61
Use on circular structures 62
Corner platforms 63
Use as working and safety scaffold 64
Components
Components 66
Instructions for Assembly and Use – Standard Configuration
Content
Introduction
Overview, Main Components 1
Standard Configuration 3
Intended Use 3
Safety Instructions 4
General 4
Load Models 5
Standard work flow 6
A1 Assembly of the CB 160 platforms
Required resources 8
Assembly of Console Bracket CB 160 9
Assembly of girders 10
Assembly of Adjusting Unit CB 160 12
Assembly of Guardrail Post CB 12
Assembly of decking 13
Assembly of guardrails 14
A2 Other assembly work
Assembly of end guardrail posts 16
Assembly of hinged hatch cover 17
Assembly of finishing platform 18
Finishing tasks 19
B1 Work on the construction site
Anchoring 20
Mounting the climbing platform CB 160 26
Mounting the finishing platform CB 160 28
Assembly of wind bracing 31
Removal of the climbing cones 33
Dismantling 33
Ladder assembly 34
B2 Assembly of formwork elements
VARIO GT 24 element 36
TRIO element 40
CB 160 Climbing Formwork
Key
Safety instructions Note Visual check Tip Load-bearing point
To Next Page
Loading...
