45Instructions for Assembly and Use – Standard Configuration
CB 160 Climbing Formwork
B3 Formwork Utilisation
Formwork alignment
Height adjustment with the
Connector TRIO-CB
1. On the top Connector, alter the
adjusting spindle (4.8) for necessary
clearance.
2. On the lower Connector, lower ad-
justing spindle (4.8) onto the locking
pin (4.6).
(Fig. B3.05)
3. Turn adjusting spindle using the ratchet
lever SW 19 and bring formwork into
position.
Depending on the rotational direction,
the formwork moves upwards or
downwards.
(Fig. B3.04)
Is there enough clearance for adjust-
ment on the top connector?
Fig. B3.06
Fig. B3.07
Fig. B3.05
Fig. B3.04
4.54.7
4.8
4.6
4.3
4.8
4.6
4.8
4.3
4.4
10.4
10
Height adjustment with the
Height Adjusting Unit CB
Apply ratchet lever SW 19 to adjusting
spindle (4.8) of the Height Adjusting
Unit CB (4.3) on the strongback.
Depending on the rotational direction,
the formwork moves upwards or down-
wards.
(Fig. B3.06 + B3.07)
Permissible load see C1.
– If the formwork does not move, loos-
ening of the Waler Fixation (4.4) will
make the adjustment easier.
– By placing a spirit level on the form-
work waler line (10.4), exact adjust-
ment is possible.
To Next Page
Loading...
