29
Programming Configuring using the ICS Switchbox
Introducing a tilt pause at 0° position
To specify whether there should be a short pause in tilting on reaching the 0° position, press button 6.
This function is only appropriate for chairs with an adapter for -5° tilt.
When LED 4 lights up green, there will be a pause in the tilt movement.
When LED 4 lights up red, there will be no pause in the tilt movement.
Pausing the legrest actuator in speed reduction mode
To specify whether the legrests temporarily stop before entering or leaving the range at which the
wheelchair’s speed is reduced because of the legrest positions, press button 3.
This function is only appropriate for chairs with front casters.
When LED 5 lights up green, the legrests will pause.
When LED 5 lights up red, the legrests will not pause.
Settings on page 2 in the Set-up menu
Keeping the legrests within the permitted range during tilt
To specify whether the legrests are to be kept within the max. or min. position automatically during tilt,
press button 1.
If this function is enabled, the legrest angle during tilt will be changed to ensure it does not exceed the
max. or min. position.
When LED 1 lights up green, the legrest position remains within the permitted range during tilt.
When LED 1 lights up red, tilt stops when the legrest angle reaches the max. or min. position.
Keeping the backrest within the permitted range during tilt
To specify whether the backrest is to be kept within the max. or min. position automatically during tilt,
press button 5.
If this function is enabled, the angle of the backrest to the seat plane during tilt will automatically be
changed when the backrest reaches the max. or min. position.
When LED 2 lights up green, the backrest position remains within the permitted range during tilt.
When LED 2 lights up red, tilt stops when the backrest angle reaches the max. or min. position.
Inverting the elevator direction through the switchbox
To adjust whether the direction of the elevator will be inverted when operated with the ICS switchbox,
press button 2.
• When LED 3 lights up green, the elevator will move up when the rear button is activated.
• When LED 3 lights up red, the elevator will move up when the front button is activated. (standard).
Inverting the tilt direction through the switchbox
To adjust whether the direction of the tilt will be inverted when operated with the ICS switchbox, press
button 6.
• When LED 4 lights up green, the tilt will move forward when the rear button is activated.
• When LED 4 lights up red, the tilt will move forward when the front button is activated. (standard).
To Next Page
Loading...