14Readying the camera systemXT Camera System Manual |
Restore to Default
LED Lights
The IQ4 feature two main LEDs located below the bottom left corner of the
screen.
A Blue LED will show when you power the IQ4 on. Two Red LEDs indicates
that the back is going through the boot up procedure.
When capturing an image the Green LED will blink rapidly to indicate that the
IQ4 is busy and that there are images in the buer that needs to be cleared to
the XQD card, the SD card and/or the local storage.
A Red LED indicates that the IQ4 is writing to the storage media, and
therefore the buer has not been emptied.
Restoring the defaults
The IQ4 is supplied preconfigured with a number of default settings ready for
use, either when purchased by itself, or with the XT.
After adjustment of these settings, you can restore the back to the factory
defaults from the back’s screen by pressing Menu > System Settings >
Restore to Default.
LED Lights
To Next Page
Loading...
