Telemetry Functions at the Information Center
Telemetry Functions at the Information Center & TeleMon
9-3
To Initiate a Spot Check Measurement
Move the cursor over the SpO
2
label. Then click on the Spot Check icon.
.
Note—There is no audio feedback at the transceiver (pulse tone or successful/
failed measurement) when Spot Check is initiated at the Information Center.
To Initiate Standby
See instructions under “Standby Mode” on page 4-4.
Locating the
Transceiver
(Find
Device)
The Find Device feature enables you to generate an alternating pitch repeated
tone at the transceiver to assist in locating a missing device. This function is
initiated in the Telemetry Setup Window. Find Device requires that the
transceiver has good working batteries and is within the coverage area. The
device will not return from out-of-range until association with the Information
Center is re-established.
To locate a
transceiver
Step Action
1 From the Patient Window, select Telemetry Setup.
2 Select Find Device to generate a repeated tone at the transceiver.
To Next Page
Loading...
Need help?
General
