Transceiver Use with Other Equipment
1-10 Introducing IntelliVue Telemetry
Patient
Bedside
Monitors
Remote control of monitoring parameters such as NBP, SpO
2
, Alarm Suspend,
and Relearn, as well as limited overview of waves and data are supported
through Patient Bedside Monitors equipped with IntelliVue Instrument
Telemetry. Please refer to the Instructions for Use for the specific Patient
Monitor for operating information.
Patient Data can be sourced directly from the transceiver to MP5/MP5T, MP2 or
X2 Patient Monitors. The connection is made through a monitor interface cable
(MP5/MP5T only) or short range radio adapter (SRRA) inserted in the Monitor/
Service port and connected to the monitor. Non-networked MP5/MP5T
monitors can source patient data that includes SpO
2
, NBP and predictive
temperature measurements to the Information Center. Please refer to the MP5
Instructions for Use for additional information.
M2601B
Transmitters
If your hospital uses TRx and/or TRx
+
Transceivers and M2601B Transmitters,
you can distinguish between them by:
• Name on the front of the device (TRx or M2601B)
• Label color (light gray for transceivers, dark gray for transmitters)
To Next Page
Loading...
Need help?
General
