Planmeca Compact i Classic v2 User Manual

22.3.3 Instrument light
Steps
1. Activate the instrument.
2. Press Program.
3. Press Reverse.
4. Adjust the light intensity.
The minimum value is 70% of the maximum intensity and the maximum
100%, and the adjustment step is 2.
After reaching the minimum value the light is switched off.
The light intensity is displayed on the control panel. 'L.oFF’ means that
the light is switched off.
5. Press Program.
22.3.4 Planmeca Lumion Plus polymerisation light
About this task
NOTE
The duration of the polymerisation cycle can be programmed only for the
Planmeca Lumion Plus polymerisation light.
Steps
1. Activate the instrument.
2. Press Program.
3. Press Reverse.
NOTE
Alternatively, you can press Instrument spray or Chip blow.
4. Adjust the length of the polymerisation cycle.
The value range is 5 - 100 seconds. The adjustment step is 5 sec. and
the default value is 10 sec.
22 Programming
100 Planmeca Compact i User's manual

Planmeca Compact i Classic v2 Specifications

General

Brand	Planmeca
Model	Compact i Classic v2
Category	Dental equipment
Language	English