3. Adjust the duration of the bowl rinsing.
The letter ‘b’ on the control panel indicates that the duration of the bowl
rinsing is adjusted.
If the letter 'c' is displayed, it means that the duration of the cup fill is
adjusted. To change the function to be adjusted, press Cup fill / bowl
rinse.
The minimum value is 5 seconds and the maximum 240 seconds, and it
is adjusted in steps of 5.
4. Press Program.
22.4.3 Duration of cup filling
About this task
NOTE
By default, the cup fill is not activated unless the cup is positioned in its
place under the cup fill tube. To change this setting, contact your Planmeca
dealer.
NOTE
The water in the dental unit is intended for rinsing only, not for drinking.
Steps
1. Press Program.
2. Press Cup fill / bowl rinse.
3. Adjust the duration of the cup filling.
The letter ‘c’ on the control panel indicates that the duration of the cup
filling is adjusted.
If the letter 'b' is displayed, it means that the duration of the bowl rinse is
adjusted. To change the function to be adjusted, press Cup fill / bowl
rinse.
The minimum value is 2 seconds and the maximum is 10 seconds. The
duration is adjusted in steps of 0.5 seconds.
4. Press Program.
22 Programming
102 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
