Foot control related error messages
ERROR
CODE
EXPLANATION
E54.9 Foot control calibration error.
E55 Wireless foot control connection lost.
27.3.8 Operating light related error messages
Operating light related error messages
ERROR
CODE
EXPLANATION
E56 Operating light erroneously connected or short circuit in push
button.
E57 Incompatible SingLED software.
E58 Operating light bulb burned out.
Replace bulb.
27.3.9 Separator system related error messages
Separator system related error messages
ERROR
CODE
EXPLANATION
E59.1 Separator reports functional error.
Refer to Metasys separator documentation.
E59.2 Separator reports functional error.
Refer to Dürr separator documentation.
E60 Separator is not responding or separator cable is faulty.
E61 Separator is flooded with too much water.
E62 Newly attached separator is of new type and cannot be
controlled by MCB.
E63.1 Water management system (WMS) seems to be installed,
although it should not be (according to service mode).
E63.2 No Water management system (WMS) is installed, although it
should be according to service mode.
27.3.10 Patient chair related error messages
Patient chair related error messages
ERROR
CODE
EXPLANATION
E64 Lift motor position potentiometer or its cable is faulty or
disconnected.
E65 Lift motor does not run or no signal from position
potentiometer.
27 Help and error messages
158 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
