NOTE
If you press the Rinsing position button for longer than 1 second when
moving the chair to the rinsing position, you will enter the position normally,
but when the chair stops in the rinsing position, the indicator light goes off
and the chair does not remember its previous position.
NOTE
If you press and hold the Rinsing position button when the chair is in the
rinsing position, the indicator light goes off, and the chair will forget the
previous position (the return function is inactivated).
NOTE
The unit can be set up so that the Rinsing position indicator light goes off
and the previous position is not stored when you are driving from the rinsing
position to a preprogrammed position. Next time you press Rinsing position,
the chair will move to the rinsing position. Contact your Planmeca dealer.
NOTE
Automatic cup fill and bowl rinse functions when the dental unit reaches the
rinsing position are configurable; contact your Planmeca dealer.
NOTE
The water in the dental unit is intended for rinsing only, not for drinking.
18.2.4 Stopping chair movements
To stop the chair from moving before it reaches the preprogrammed
position, press any chair button on the Flexy-holder, push the foot control
pedal in any direction, or push the foot control centre knob in any direction.
The chair movement stops also when the stop plate is pushed or when the
backrest is pressed upward. The chair can be driven normally after the
possible obstruction has been removed.
1. Stop plate
2. Backrest
18 Operating patient chair
User's manual Planmeca Compact i 65
To Next Page
Loading...
Need help?
General
