2. Place the rinsing bottle on a flat surface (table or floor).
3. Remove the suction handpieces from their holders and push them onto
the inserts inside the cap of the rinsing bottle.
4. Remove the suction handpieces from the rinsing bottle when there is 250
ml of the solution left in the bottle.
5. Return the suction handpieces immediately back to the holder. Do not
use suction only for air.
6. Open the bowl valve to remove any excess water by pressing the
Program button for about 5 seconds until the suction starts. The valve
will close automatically after about 15 seconds.
7. When the valve has closed, pour the 250 ml that is left of the solution
into the bowl.
8. Let the solution affect for 30 - 120 minutes.
9. Rinse the bowl by pressing Bowl rinse.
10. Rinse the suction tubes by manually aspirating water through the suction
handpieces.
24.5.4.2 After working day
About this task
If your dental unit is equipped with a Dürr amalgam separator or Dürr VS/A
separator, you must clean the suction system with Planmeca approved
suction disinfectant once a week.
Steps
1. Mix 5 ml of Planmeca approved suction disinfectant with 250 ml water
and stir well.
2. Open the bowl valve to remove any excess water by pressing the
Program button for about 5 seconds until the suction starts. The valve
will close automatically after about 15 seconds.
3. When the valve has closed, pour the suction disinfectant solution into the
bowl.
24 Cleaning and disinfection
126 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
