Polaris Sportsman XP 1000 S 2021 - Stator; Alternator Installation; Stator; Alternator Test

4.30
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
STATOR / ALTERNATOR INSTALLATION
1. Reverse the “Stator / Alternator Removal” procedure
to reinstall the stator.
2. Use the following steps to ensure proper assembly.
3. Torque the stator
q
and wire guide
w
bolts to
specification.
4. Install new O-rings
e
on the coolant pipe and lightly
lubricate for ease of installation.
5. Torque the (8) stator cover fasteners to specification
using the torque sequence provided.
STATOR / ALTERNATOR TEST
Three tests can be performed using a multimeter to
determine the condition of the stator (alternator).
TEST 1: Resistance Value of Each Stator Leg
1. Measure the resistance value of each of the three
stator legs.
STATOR RESISTANCE VALUES
TEST
CONNECT METER
LEADS TO:
OHMS
READING
Charge Coil Y1 to Y2 (Pin B to C)
0.13 Ω ± 15%
Charge Coil Y1 to Y3 (Pin A to C)
0.13 Ω ± 15%
Charge Coil Y2 to Y3 (Pin A to B)
0.13 Ω ± 15%
NOTICE
If there are any significant variations in ohm readings
between the three legs, one of the three stator legs may
be weak or failed.
TEST 2: Resistance Value of Each Stator Leg to
Ground
ENGINE ELECTRICAL