EasyManua.ls Logo

Polaris Sportsman XP 1000 S 2021 - Engine Service; Accessible Engine Components; Top-End Service (Engine in Chassis); Engine Removal

Polaris Sportsman XP 1000 S 2021
528 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
3.41
ENGINE SERVICE
ACCESSIBLE ENGINE COMPONENTS
Components serviceable with engine installed:
Flywheel
Alternator (Stator)
Starter Motor / Solenoid
Cylinder Head / Valves
Camshaft / Camshaft Carrier
Rocker Arms
Water Pump
Components that require engine removal for service:
Counterbalance Shaft(s)
Piston / Rings
Connecting Rod
Crankshaft / Main Bearings
Oil Pump
Crankcase
Crankshaft End Seals (Use A-49320)
TOP-END SERVICE (ENGINE IN
CHASSIS)
The top-end of the engine can be serviced while the
engine is mounted in the chassis. A removable upper
right-hand frame support allows access to the valve
cover and cylinder head.
To service the top-end of the engine refer to the “Valve
Clearance Adjustment” procedure in the Maintenance
chapter, which provides detailed steps to access the
valve cover.
ENGINE REMOVAL
IMPORTANT
Some engine repair procedures can be performed
without removing the engine from the vehicle. See
Accessible Engine Components page 3.41 for further
information.
NOTICE
Upon engine removal, use a mechanical lift or have an
assistant help remove the engine from the vehicle to
prevent personal injury or damage to vehicle
components.
1. If vehicle was recently operated, allow it to cool down
before attempting to perform any work.
2. Thoroughly clean the engine and chassis.
3. Clean your work area.
4. Drain the engine oil (see Maintenance chapter).
5. Remove the following body components. See Body /
Frame chapter for component removal.
Seat
Side Panels (upper and lower)
Footwells
Mud Guards (both sides)
Front Rack or Storage Box
Front Cab
6. Disconnect negative (-) battery cable.
7. Pull the shift linkage rod straight outward while
pushing on the two ears of the snap retainer
q
to
disconnect the rod from the shift lever. Allow the
linkage to hang down out of the way.
8. Remove the high tension leads
w
from the engine
and remove the nuts
e
from each exhaust flange at
the engine.
ENGINE / COOLING SYSTEM

Table of Contents

Related product manuals