1.40
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
4. Once the installation is complete, launch the Digital
Wrench® software and verify the information in the
lower, right-hand corner matches the new Base
Version you just installed.
DIGITAL WRENCH® DIAGNOSTIC
CONNECTOR
Refer to the Engine Electrical chapter for the following
information:
• Location of the Digital Wrench® diagnostic connector
• Instructions on how to connect the diagnostic
connector to the vehicle
DIGITAL WRENCH® COMMUNICATION
ERRORS
If you experience problems connecting to a vehicle, or
any other Digital Wrench® software-related problem, visit
the Digital Wrench® home page (www.polaris.diagsys.
com) and locate the following information under
Knowledge Base:
• Errors and Troubleshooting
• Frequently Asked Questions (FAQs)
• Procedures and Solutions
DIGITAL WRENCH® SERIAL NUMBER
LOCATION
To locate the Digital Wrench® serial number, do the
following:
1. Launch the Digital Wrench® software.
2. On the Digital Wrench® main screen, select the
‘Configure the Diagnostic System Software’ menu
icon.
3. Locate the serial number on the right side of the
System Configuration screen.
GENERAL INFORMATION
To Next Page
Loading...
