This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01MMUTEB,R1,1
Mute signal path (in
main matrix) from
input B to AEC
reference 1 .
Q01MMUTEB,R1,1
Q01MMUTEWB0,WM0,0
Mute signal path (in EF
Bus W submatrix) from
W bus signal at device
ID0 (WB0) to W
submatrix output 0
(WM0).
Q01MMUTEWB0,WM0,0
Q01MMUTE1,B,2
Toggle mute status of
signal path (in main
matrix) from input 1 to
output B .
Q01MMUTE1,B,x , where x is either 0 or 1
depending on the current mute status of the
crosspoint.
Q01MMUTEA,W,?
Query mute status of
signal path (in main
matrix) from input A to
W-Bus output .
Q01MMUTEA,W,x , where x is either 0 or 1
depending on the current mute status of the
crosspoint.
Q01MMUTE1,*,01100000
Set all crosspoint
mutes for input
channel 1. Mute the
paths from input 1 to
outputs A and B, and
unmute the paths from
input 1 to outputs 1,
R1, and W-Z.
Q01MMUTE1,*,01100000
Q01MMUTEA,*,0
Unmute all crosspoints
for input channel A .
Q01MMUTEA,*,00000000
Q01MMUTEA,*,2
Toggle all crosspoint
mutes for input
channel A .
Q01MMUTEA,*,abcdefgh , where the value of
each of letters (a, b, etc.) is either 0 or 1
depending on the current state of each of the
crosspoint mutes. If this command was issued
after the example above, then the status
message would be Q01MMUTEA,*,00000000
Q01MMUTEA,*,?
Query all crosspoint
mutes for input
channel A .
Q01MMUTEA,*,abcdefgh , where the value of
each of letters (a, b, etc.) is either 0 or 1
depending on the current state of each of the
crosspoint mutes. If this command was issued
after the example above, then the status
message would be Q01MMUTEA,*,00000000
To Next Page
Loading...
