Power Electronics SD300 Series - Page 108

SD300
POWER ELECTRONICS
106
DESCRIPTION OF PROGRAMMING PARAMETERS
Screen
Description
Default
value
Range
Function
Set
on
RUN
drv
[1]
Control mode
1
1 =
Remote
0 to 5
Set the control mode to command the drive
(Start/Stop, Reset...).
OPT.
DESCR.
FUNCTION
0
LOCAL
Drive is controlled from the
keypad.
1
REMOTE
Commands are sent from
the control terminals.
2
REMOTE
2
Commands are sent from
the control 2 terminals.
3
MODBUS
The drive is controlled
through the
communications bus,
integrated in the
equipment.
4
COMMS
The drive control is carried
out by the use of any of the
optional communication
boards.
5
PLC
The common area can be
linked with the user
sequence output and can
be used as command.
NO
[1] Displayed when an LCD keypad is in use.