Power Electronics SD300 Series - Page 111

POWER ELECTRONICS
SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
109
Screen
Description
Default
value
Range
Function
Set
on
RUN
dr.9
Control type
V/Hz
0 to 6
Define the drive control type.
OPT.
DESCR.
FUNCTION
0
V/Hz
A linear V/Hz pattern
configures the drive to
increase or decrease the
output voltage at a fixed
rate for different operation
frequencies. This is
particularly useful when a
constant torque load is
applied.
2
SlipCom
Slip refers to the variation
between frequency
(synchronous speed) and
motor rotation speed. As
the load increases, there
can be variations between
the set frequency and
motor rotation speed. Slip
compensation is used for
loads that require
compensation of these
speed variations.
NOTE: Continues on the next page.
NO