Power Electronics SD300 Series - Page 115

POWER ELECTRONICS
SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
113
Screen
Description
Default
value
Range
Function
Set
on
RUN
dr.81
Select
monitor code
Volt V
0 to 2
Select the monitor code.
OPT.
DESCR.
FUNCTION
0
Volt V
Scalar control mode. Drive
carries out the control
applying a voltage /
frequency ramp to the
motor.
1
Pot kW
Control by power.
2
Tq kgf
Control by torque.
YES
dr.89
Display
changed
parameters
All
All
Chang
Displays all parameters that are different from
the factory default values. Use this feature to
track changed parameters.
OPT.
DESCR.
FUNCTION
0
All
Display all parameters.
1
Chang
Display changed
parameters.
YES
dr.90
ESC key
function
Mov.
Pos. In
0 to 2
The [ESC] key is a multi-functional key that can
be configured to carry out a number of different
functions.
OPT.
DESCR.
FUNCTION
0
Mov. Pos.
In.
Move to the initial position.
1
JOG Key
Perform a jog operation.
2
Local/Rem.
Change from Local to
remote control if the key
has previously been
configured as such.
NO
dr.91
[1]
Eloader
function
None
0 to 2
Set Eloader function.
OPT.
DESCR.
FUNCTION
0
None
No actions are executed.
1
Download
Download upgrade file.
2
Upload
Store drive current values.
NO