Power Electronics SD300 Series User Manual

SD300
POWER ELECTRONICS
118
DESCRIPTION OF PROGRAMMING PARAMETERS
Screen
Description
Default
value
Range
Function
Set
on
RUN
bA.4
Control mode
2
1
0 to 4
Set the alternative control mode to command
the drive (Start/Stop, Reset...).
OPT.
DESCR.
FUNCTION
0
LOCAL
Drive is controlled from
the keypad.
1
REMOTE
Commands are sent from
the control terminals.
2
REMOTE
2
Commands are sent from
the control 2 terminals.
3
MODBUS
The drive is controlled
through the
communications bus,
integrated in the
equipment.
4
COMMS
The drive control is carried
out by the use of any of the
optional communication
boards.
NO
bA.5
Speed
reference
source 2
LOCAL
0 to 12
Select the alternative source for the speed
and torque reference respectively.
OPT.
DESCR.
FUNCTION
0
LOCAL
Reference will be given
by keypad and will be set
in dr.1.
2
V1
Reference will be
introduced through the
voltage analog input 1.
4
V2
Reference will be
introduced through the
voltage analog input 2.
5
I2
Reference will be
introduced through the
current analog input 2.
Note: Continues in the next page
YES

Power Electronics SD300 Series Specifications

General

Brand	Power Electronics
Model	SD300 Series
Category	Inverter
Language	English