ELECTROMAGNETIC COMPATIBILITY (EMC)
• The drive is intended to be used in industrial environments (Second
Environment). It achieves compliance with C3 category defined in IEC/EN
61800-3 standard when the installation recommendation within this
manual are followed.
• Select communication and control system according to the drive EMC
environment. Otherwise, systems could suffer from interferences due to a
low EMS level.
SAFETY
Before operating the drive, read this manual thoroughly to gain an understanding
of the unit. If any doubt exists, please contact POWER ELECTRONICS, (902 40
20 70 / +34 96 136 65 57) or your nearest agent.
• Wear safety glasses when operating the drive with power applied or for
when the front cover is removed.
• Handle and transport the drive following the recommendations within this
manual.
• Install the drive according to the instructions within this manual and local
regulations.
• Do not place heavy objects on the drive.
• Ensure that the drive is mounted vertically and keeping the minimum
clearance distances.
• Do not drop the drive or subject it to impact.
• The SD300 drives contain static sensitive printed circuits boards. Use static
safety procedures when handling these boards.
• Avoid installing the drive under conditions that differ from those described
in the Environmental Ratings section.
To Next Page
Loading...
Need help?
General
