Power Electronics SD300 Series - Page 166

SD300
POWER ELECTRONICS
164
DESCRIPTION OF PROGRAMMING PARAMETERS
Screen
Description
Default
value
Range
Function
Set
on
RUN
In.67
Digital input 3
RESET
0 to 54
Note: Comes from the previous page.
OPT.
DESCR.
FUNCTION
12
XCEL-M
Bit 1 for alternative
acceleration ramps.
Allows the selection of the
multiple preconfigured
acceleration/deceleration
ramps.
See bA.70 to bA.83.
13
RUN
Enable
Sets the digital input to
safe operation mode.
14
3 WIRE
Configure digital inputs
for a behaviour with
pulses. This input is
configured as NC and
acts as stop towards the
start command.
Example:
DI1 = 1➔ START(+)
(NO)
DI2 = 14➔ 3 WIRE (NC)
DI3 = 18➔ DOWN (NO)
Button DI1 orders to start
and the requests from DI2
are stopped. Button DI3
slows speed down.
15
CTR/REF
2
Enables the alternative
control mode
programmed in bA.4
(NO).
Note: Continues on the next page.
NO