Power Electronics SD300 Series - Page 165

POWER ELECTRONICS
SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
163
Screen
Description
Default
value
Range
Function
Set
on
RUN
In.66
Digital input 2
START
(-)
0 to 54
Note: Comes from the previous page.
OPT.
DESCR.
FUNCTION
7
SPEED-L
Bit 0 speed reference.
Allows selecting the
multiple preconfigured
speed references. See
St1-St3 and bA.53 -bA.56
(NO).
8
SPEED-M
Bit 1 speed reference.
Allows selecting the
multiple preconfigured
speed references. See
St1-St3 and bA.53 -bA.56
(NO).
9
SPEED-H
Bit 2 speed reference.
Allows selecting the
multiple preconfigured
speed references. See
St1-St3 and bA.53 -bA.56
(NO).
11
XCEL-L
Bit 0 for alternative
acceleration ramps.
Allows the selection of the
multiple preconfigured
acceleration/deceleration
ramps.
See bA.70 to bA.83.
Note: Continues on the next page.
NO