Power Electronics SD300 Series - Page 168

SD300
POWER ELECTRONICS
166
DESCRIPTION OF PROGRAMMING PARAMETERS
Screen
Description
Default
value
Range
Function
Set
on
RUN
In.69
Digital input 5
MultVel-
B
0 to 54
Note: Comes from the previous page.
OPT.
DESCR.
FUNCTION
20
POT
CLEAR
Reset to 0 the speed
reference of the motorized
potentiometer. This way,
even if parameter Ad.65 is
set to NO, when restarting
the drive, the drive will
operate at the reference
set in dr.1.
21
Analog
HLD
Set a speed reference
from an analog input to the
present activation time
value. When this digital
input is active, the drive
will ignore any change
produced in the analog
input reference (NO).
22
I-Term
Clear
Reset the accumulated
error by the integral PID
function.
23
PIDOP
Loop
Allow disabling the PID
function. When it is
disabled, the control PID
will be resumed.
Note: This option must be
used when the PID
reference is set by
analogue input. If PID
reference is set by display,
use option ‘INCH1’.
24
PGain2
Set the proportional gain
2 for PID operation.
Note: Continues on the next page.
NO