Power Electronics SD300 Series User Manual

POWER ELECTRONICS
SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
177
Screen
Description
Default
value
Range
Function
Set on
RUN
Note: comes from the previous page
OPT.
DESC.
FUNCTION
6
IOL
The relay will be active in
case a fault due to
overload protection
occurs.
7
Undr
Load
The relay will be active in
case of an underload
warning.
8
VentWa
rn
The relay will be active in
case a fan fault occurs
and parameter Pr.79 is set
as 1 ‘WARN’.
9
Stall
Digital output will be
enable when the motor is
blocked and overcharged.
10
OverVol
t
The relay will enable
whenever the drive DC
bus voltage is higher than
the protection voltage.
11
LowVolt
The relay will be active
whenever the drive DC
link voltage drops below
the low voltage protection
level.
12
Over
Heat
The relay will enable when
the drive temperature
reaches a dangerous
level.
13
Lost
Comma
nd
Communications have
been interrupted.
Note: continues on the next page.

Power Electronics SD300 Series Specifications

General

Brand	Power Electronics
Model	SD300 Series
Category	Inverter
Language	English