Power Electronics SD300 Series - Page 299

354 pages

To Next Page

To Previous Page

POWER ELECTRONICS

SD300

COMMONLY USED CONFIGURATIONS

297

Connection scheme

Terminals CM/P1: Start commando (NO state).

Terminals I2/CM: Analogue input 4 – 20mA.

Terminals VR/V1/CM: Analogue input 0 – 10V.

Start/Stop command by terminals and speed setting by analogue input

Main Page

About this Manual4
Table of Contents6
Safety Symbols9
Safety Instructions10
1 Introduction16
2 Configuration Table & Standard Ratings17
- Configuration Table17
- Standard Ratings - 230VAC Single-Phase18
- Standard Ratings - 230VAC 3-Phase18
- Standard Ratings - 400VAC19
3 Technical Characteristics21
- Enhanced Sensorless Control24
4 Dimensions26
- IP20 Drives Dimensions26
- IP66 Drives Dimensions37
5 Reception, Handling and Transportation42
- Reception and Storage42
- Handling and Transportation42
6 Mechanical Installation44
- Environmental Ratings44
- Drive Mounting45
- Clearances46
- Cooling48
7 Power Connections51
- Basic Configuration51
- Topology52
- Power Terminals53
- Power Connection and Wiring60
- Ground Connection64
- EMC Installation Requirements65
- Protections70
- Dynamic Braking Resistors72
8 Control Connection74
- Wiring Recommendations74
- Control Cables Access75
- Control Board Terminals Description76
- Control Switches82
- STO - Safe Torque off82
9 Commissioning84
10 Maintenance87
- Cooling87
- Warnings88
- Routine Inspection88
11 Use of the Display92
12 Status Messages96
- List of Status Messages96
13 Warning & Fault Messages97
- List of Warning Messages97
- List of Fault Messages & Troubleshooting99
14 Description of Programming Parameters106
- Group 0: Operation106
- Group 1: Drive → Dr107
- Group 2: Basic Functions → Ba118
- Group 3: Expanded Functions → Ad130
- Group 4: Control Functions → Cn143
- Group 5: Inputs → in160
- Group 6: Outputs → OU175
- Group 7: Communication Bus → CM184
- Group 8: PID → AP190
- Group 9: Protections → Pr197
- Group 10: Second Motor → M2209
- Group 11: PLC Sequence → US212
- Group 12: PLC Function → UF214
15 Modbus Communication221
- Introduction221
- Supported Modbus Function Codes225
- Addressing Modes228
- Summary of Modbus Addresses229
16 Accessories276
- Communications277
- Extension I/O277
- Conduit Kit278
- Flange Type279
17 Commonly Used Configurations292
- Start/Stop Command and Speed Setting from Keyboard292
- Start/Stop Command by Keyboard and Speed Setting by Analogue Input294
- Start/Stop Command by Terminals and Speed Setting by Analogue Input297
- Multi-Speed Commands (Multi-Step Frequencies) Using P5, P6 and P7300
- Constant Pressure Control and Automatic Stop at Zero Level Flow303
- Speed Control (Up/Down Potentiometer) and Start/Stop Commands by Terminals306
- Permanent Magnet Synchronous Motor Control309
18 Configuration Register318
Declaration of Conformity Ce351

Related product manuals

Power Electronics SD700

101 pages

Power Electronics SD700 Series

105 pages

Power Electronics SD300 Series - Page 299

Table of Contents

Related product manuals