Power Electronics SD300 Series - Page 328

SD300
POWER ELECTRONICS
326
CONFIGURATION REGISTER
PARAMETER
DEFAULT
VALUE
SETTING 1
SETTING 2
Cn.44
PM speed estimator integral
gain 2
30
__________________
__________________
Cn.45
Speed estimator feedforward
high speed range (%)
300%
__________________
__________________
Cn.46
Initial pole position estimation
type
1: Angle
Detect
__________________
__________________
Cn.48
Controller P gain
1200
___________________
___________________
Cn.49
Controller I gain
120
___________________
___________________
Cn.50
Voltage controller limit
10.0%
__________________
__________________
Cn.51
Voltage controller I gain
10.0%
__________________
__________________
Cn.52
Output filter vector
0ms
___________________
___________________
Cn.53
Torque limit reference
LOCAL
___________________
___________________
Cn.54
Forward positive torque limit
180.0%
___________________
___________________
Cn.55
Forward negative torque limit
180.0%
___________________
___________________
Cn.56
Reverse positive torque limit
180.0%
___________________
___________________
Cn.57
Reverse negative torque limit
180.0%
___________________
___________________
Cn.62
Speed limit reference
LOCAL
___________________
___________________
Cn.63
Forward speed limit
50.00Hz
___________________
___________________
Cn.64
Reverse speed limit
50.00Hz
___________________
___________________
Cn.65
Speed limit gain
500%
___________________
___________________
Cn.70
Speed search mode selection
Flying
Start1
___________________
___________________
Cn.71
Search mode
0000
___________________
___________________