4.3.2.1 Disassembly of wheel components:
Remove M10 Conical Nuts (4pcs) and detach the tire.
(Figure 4-2-13)
4.3.2.2 Inspection of wheel components:
1. Check if the wheel hub has any distortion, rust, crack or
other potential defects. If so, please replace the wheel hub.
2、Check if the tire has reached its maximum wear condition in
which case it should be replaced.
3、Check the joining condition of the tire and wheel hub. If
the joint of tire and wheel hub is loose, replace the tire
immediately.
4、Check the vibration of tire/wheel hub. (Figure 4-2-13)
Vibration of assembled Tire must be
controlled within 3mm. Otherwise, please
replace with new tire.
Remove the tire for vibration test of the
wheel hub. Should the vibration exceed
1.2mm, the wheel hub must be replaced.
5、Inspect the four conical bores on the wheel hub.
In occasion of angular distortion or wear, the wheel
hub must be replaced.
4.3.2.3 Assembly of wheel:
To Next Page
Loading...