3. Disassemble the fore bridge differential (Figure 4-2-20)
4、Take out the fore bridge from the frame
5、Release engine oil in the differential
6、Unplug the transmission shaft from the differential
(Figure 4-2-19)
4.4.1.3
Inspection and Maintenance of fore bridge:
1. If the dust-proof Rubber Sheath of the transmission
shaft is worn out or cracked, please have it replaced
immediately.
2、Check whether the ball is running smoothly. If found
loosen or stunk, replace the transmission shaft.
3、 disassemble the transmission shaft, clean, then
install,
Caution: 1. the dust-proof Rubber Sheath can not be
touched by petrol and diesel oil.
2 The dust-proof Rubber Sheath must not be
cracked for slight scratch may be damaged
the Rubber Sheath.
3. Inject 2/3 Lithium Lubrication into the
ball.
To Next Page
Loading...