Yanggakdo.
3. Check if the constant velocity joint is matched up well.
If not so or there is gear-cracked and abnormal noise,
remove the constant velocity joint and align it.
4. Check if there exists any slip thread or flaw on the
open-groove nut.
5...Disassemble the front tank and check whether the
gears
Is engaged properly.
6...In case the choke is jammed, it must be dredged with
a needle. If the problem is not solved, replaced it.
7. If there are defects on sensors, it must be checked
and maintained by a professional.
8. Gears are fragile commodities in transmission system.
4.4.1.2 Disassembly of fore bridge component:
1. Detach the two front wheel parts.
2. Removed front Disk Brake Clip, cotter pin, cushion
and the front wheel hub. (Figure 4-2-20)
Figure 4-2-20
To Next Page