10.5 5、drive gear of front bridge
6、front driving axis pin sleeve 7、M10X1.25 flange locknut 8、0-ring of front
bridge drive gear f9、φ65Xφ48oil seal 10、oil seal of rear constant velocity
joint assembly 11、differential –adjusted washer
12、M8X20 engine gearbox bolt 13、differential assembly 14、inner hex bolt M8X25
15、inner hex bolt M8X10 16、hexagon flange bolt M10×25
17、clip used inφ66 18、φ5X80 cylindrical pin 19、engine gearbox assembly 20、
adaptor 21、cog rack
22、fork 23、0-rings of engine gearbox 24、0-rings of front cover 25、deep-groove
ball bearing6007 26、deep-groove ball bearing 6912 27、deep-groove ball bearing 16007
28、needle bearing15BM2112 29、M10X16 oil-change bolt 30、φ10X1.5 cooper gasket
31、power divider coupling 32、differential-adjusted washerⅡ 33、bolt M14X15
34、cooper gasket φ14X2 35、vent pipe of drive case 36、clip of oil pipe 37、
fore transmission shaft
38、weak spring of fore transmission shaft
39、dust-proof cover of fore transmission shaft
4.4.1 Disassembly, inspection, assembly of Rear Bridge
components(refer to the figure of fore Bridge ,fore
case components)
4.4.1.1
1. Check if the connection between wheel hub and the Bottom
Seat of wheel hub is reliable and if there is any
distortion on the Bottom Seat of wheel hub. If there
exists any such potential defects, the Bottom Seat of
wheel hub must be replaced immediately.
2. Check if the Yanggakdo and its attachments are
compatible well and if there is stagnation, slosh and
Crunch of the Yanggakdo bearing. In case the bearing
or Yanggakdo is flawed, the fore bridge must be removed
in the first instance, then replace the bearing and
To Next Page
Loading...