1、gear shift mechanism assembly 2、gear shift mechanism handle 3、换档机构
plastic screw of gear shift mechanism
4、dust-proof cover of gear shift mechanism 5、dust-proof cover thimble of gear shift
mechanism 6、velocity joint robber sheath of gear shift mechanism
7、velocity joint of gear shift mechanism 8、hex nut (anti)M8 9、waste oil pipe
thimble of gear shift mechanism
10、waste oil pipe of gear shift mechanism 11、waste oil pipe thimble of gear shift
mechanism 12、waste oil pipe robber plug of gear shift mechanism
13、hex nut (upright) M8 14、connecting rod of gear shift mechanism 15、hex nut
(anti)M8
16. Gear shift controlling 17. cushionφ6 18. Hex nut M6×36
4.5.1Inspection and Maintenance of gear shift Mechanism (refer
to the picture of gear shift Mechanism)
1. Check the mobility of gear shift handle. If it is not working
properly, remove the gear shift Mechanism to check if the fork,
ball and spring are stuck. in which case replace the defective
component and try again. The last way is to turn to the
professional repairman.
2. If there is lack in the gear shift mechanism, adjust the nut
of the fork to correct position and strengthen gear shift
mechanism.
3. Remove the gear shift mechanism and check whether the linking
rod is cracked; if so, it should be changed.
4. Check whether the bouncing spring of gear shift mechanism
is intense enough.
5. Check whether the gear is engaged correctly and whether
there is trip stop or lack. If this situation exists, call for
To Next Page
Loading...