Powtran PI8600 Series - Page 34

Section V Parameter Function Table
32
Section V
braking
frequency
time
time
Stop braking (RUN→STOP)
STOP
OFF
stop braking time
RUN
ON
setting
frequency
output
frequency
stop brake wait time
setting
frequency
forward
reverse
command
FOR
REV
stop braking (forward and reverse rotate)
time
time
setting
frequency
output
frequency
braking
frequency
stop braking time
stop brake wait time
ON
setting
frequency
output
frequency
braking
frequency
RUN
STOP
braking
frequency
stop braking time
time
time
stop braking (run state)
stop brake wait time
F32
Stop setting mode
Deceleration stop
0
-
0
N
Free stop
1
When the frequency inverter receives the "stop" command, it will set the parameters
accordingly to this parameter to set the motor stop mode.
0 : Deceleration to stop
Mode converter according to parameters set by the deceleration time to set the deceleration
mode to slow down to the lowest frequencies to stop.
1 : Free stop mode
Inverter receive "stop" command immediately stop output, according to the load inertia,
motor free-run to stop.
F33
Jog acceleration time
0.0~3200.0
s
1.0
N