5-44 Other Features
PA-1628Operator's ManualH3-45 COACH
CAUTION
Ensure that release shaft re- engages and locks when
platform is fully extended. If release shaft does not engage,
use manual pump handle and turn ¼-turn (direction opposite
to orientation shown on adjacent decal) to re- engage
release shaft.
6. Lift right handrail to vertical and push firmly down into
its socket. Repeat for left handrail.
To Manually Raise The Platform
1. Verify that rollstop is up (closed). Pull rollstop control
knob out and rotate fully clockwise, if it isn’t up.
2. Close the backup pump release valve by pushing the
actuating rod (A) DOWN (release valve should already
be closed).
NOTE
Pumping the handle raises the platform when the release
valve is closed.
3. Insert pump handle into backup pump socket (B), then
pump handle to raise the platform to the floor level.
4. Position wheelchair in center of platform, facing
outward, and advise occupant to lock wheelchair
brakes. Power must be turned off on electric-powered
wheelchairs.
NOTE
Standee must stand near the center of the platform, facing
in the direction of travel (into vehicle), and firmly grasp
handrails. Do not stand on bridgeplate.
To Next Page
Loading...
