Printronix P5210 - Page 237

Fault Messages
237
34 RIBBON STALL
TIMEOUT
Yes A timeout message
is sent to the host if
no ribbon motion
has occurred for 10
minutes after
CLEAR was
pressed to clear the
jam fault.
Clear ribbon jam and
reload ribbon.
RIBBON INK OUT
CHANGE RIBBON
Yes The RibbonMinder
program is warning
that the amount of
ink in the ribbon has
reached 0%.
Replace ribbon or press
CLEAR for two
additional minutes of
printing before the fault
displays again. See
“RIBBONMINDER” on
page 219.
RIB INVLD CMD* No Fatal firmware error
on controller board.
Contact your authorized
service representative.
1
SCS COMMAND
ERROR*
No Printer received
undefined control
character.
Contact your system
administrator.
SECURITY CODE
VIOLATION*
No Security code of
PAL on controller
board does not
match code of
firmware on the
controller board.
Contact your authorized
service representative.
1
SF ERROR* No Application
software has
violated structured
data field
parameters.
Contact your system
administrator.
SHUTL INV CMD* No Fatal firmware error
on controller board.
Contact your authorized
service representative.
1
Table 8. LCD Message Troubleshooting Table (continued)
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es