3. Insert the crimp-on terminal into the terminal block until it can go no further.
Connecting with solid wire
1. Strip 10 mm off the wire.
2. Insert the wire into the terminal block until it can go no further.
Screwdriver for terminal block
To install wiring in a terminal block, use a screwdriver with the correct dimensions. For instance, a
Phoenix Contact Screwdriver SZF 1-0.6X3.5 (article number 1204517).
Using a screwdriver that is too large or too small may damage the connections on the modules.
Connecting the supply voltage
Connect the supply voltage to the controllers and the Mix I/O modules. The other modules are
powered via the I/O bus.
Use a power supply that meets the safety requirements laid down in General specifications
of Priva Blue ID C-Line controllers and modules (page 123).
• To install wiring in a terminal block, use a suitable screwdriver. See Screwdriver for terminal
block (page 35).
• When using flexible wire, it is best to use crimp-on terminals.
35Installing Priva Compass - 00.014
Priva Blue ID hardware
To Next Page
Loading...