PROLEC James Fisher PME400 - 5.4. Supervisor Login; 5.5. User Logout

562400-000, Issue 1.3 January 2022
Page 13 of 61
5.4. Supervisor Login
To login as a supervisor, either Login as described in section 5.3,
use the supervisor key switch (if fitted) or hold any Exit icon button
down for three seconds and enter your code.
Logging out is described in section 5.5 or use the supervisor key
switch. Logging in as a supervisor is recorded in the system data
log.
Supervisor SET position is intended for set-up of envelope limiting
functions only. The keyswitch must be returned to the LIMIT
position for normal operation.
5.5. User Logout
If a user is logged in, they can select the logout screen by holding an exit key button down for
three seconds.
Once log off has been confirmed, the login screen will be automatically displayed.
Press the RED CROSS button to stay logged in, the screen will return to that previously shown.
Confirm logout
Cancel to stay
logged in
Increases highlighted
digit
Decreases highlighted
digit
Accept displayed
value
Cancel without
change
Moves highlighter to
right
Moves highlighter to
left / Hold to delete
digit