PROLEC James Fisher PME400 User Manual

562400-000, Issue 1.3 January 2022
Page 31 of 61
7.4.3. Low Limit Setting - Using Current Low
Set the limit using the current lowest point of the machine.
Step One
Step Two: Check the limit and press Green TICK to accept.
If you attempt to set a height limit below the current machine height, an
error will be shown. Move the machine to be lower than the desired
height, and then try again. Once a limit is set, the internal alarm will
sound and the RED LED will light if the equipment exceeds the current
limit. Always check that the current limit activates at the set point. The
restriction cannot be deactivated if in the alarm state. Observe the
operational limitations given in section 4.
Move equipment to
required low limit and
press this button
Exit without change
Accept the value shown

PROLEC James Fisher PME400 Specifications

General

Brand	PROLEC
Model	James Fisher PME400
Category	Controller
Language	English