PROLEC James Fisher PME400 User Manual

562400-000, Issue 1.3 January 2022
Page 23 of 61
7.2.3. Max Radius Limit Setting - Using Current furthest Point
Set the limit using the current furthest point of the machine.
Ensure the equipment is off the ground before setting the
limit.
Step One
Step Two: Check the limit and press Green TICK to accept.
If you attempt to set a height limit below the current machine height, an
error will be shown. Move the machine to be lower than the desired
height, and then try again.
Once a limit is set, the internal alarm will sound and the RED LED will
light if the equipment exceeds the current limit. Always check that the
current limit activates at the set point. The restriction cannot be
deactivated if in the alarm state. Observe the operational limitations
given in section
4
.
Move equipment to
required max radius limit
and press this button
Radius limit shown here
Exit without change
Accept the value shown

PROLEC James Fisher PME400 Specifications

General

Brand	PROLEC
Model	James Fisher PME400
Category	Controller
Language	English