PROLEC James Fisher PME400 User Manual

562400-000, Issue 1.3 January 2022
Page 30 of 61
7.4.2. Low Limit Setting - Known Low Height
A known limit can be entered into the display. This is
measured from the tool pin vertically down:
Use the UP and DOWN Arrow icon buttons to increase and decrease the highlighted number. Use the
LEFT and RIGHT Arrow icon buttons to move the highlighter to the left and to the right.
Once a limit is set, the internal alarm will sound and the RED LED will
light if the equipment exceeds the current limit. Always check that the
current limit activates at the set point. The restriction cannot be
deactivated if in the alarm state. Observe the operational limitations
given in section
4
.
Decreases highlighted
digit
Moves highlighter to
right
Increases highlighted
digit
Accept displayed
Cancel without change
Moves highlighter to left;
Move left beyond first
digit to insert “0”;
Hold to delete digit.
Exit to previous menu
Enter a value

PROLEC James Fisher PME400 Specifications

General

Brand	PROLEC
Model	James Fisher PME400
Category	Controller
Language	English